Installation Instructions - Aquatic 6030SPAN Manual De Instalación

Installation Instructions

6 6 6
Fasten a 1" x 3" (25mm x 75mm) ledger strip along the rear and sides of
framing (immediately below marks).
8 8 8
Install drain assembly per manufacturer's instructions.
Place base into framing pocket.
10 10 10
Tap down until level. Level lengthwise and widthwise using 3 ft. (915mm) level
by shimming or depressing foundation materials. The unit must be set level.
Front apron should be firmly on the floor.
Aquatic Bath • 8101 E. Kaiser Blvd., Anaheim, CA • (800) 945-2726 • www.aquaticbath.com
7 7 7
(Optional) Mix foundation material. Place three or four mounds of plaster on
the subfloor around but away from drain hole. The mounds should be placed
high enough so that when the unit is set, it will cause the plaster to displace
9 9 9
Assure waste pipe protrudes well into drain fitting.
11 11 11
Pre-drill horizontal flanges along top of base section and fasten into each
corresponding stud. Pre-drill both (vertical) side flanges and fasten to side
studs 8" (200mm) on center. Place cardboard to protect finish.
— 4 —
Installation Data
Single Seat Shower Pan
Fax on Demand # 9033
and spread.