Festo SPC200 Manual Del Usuario página 16

Fitting the modules
1. Switch off the compressed air supply and operating
voltage.
2. If applicable, unlock the locking lever and remove the
blanking plate.
3. Hold the module by the front plate and push it into the
guide rail. Make sure that the module is not tilted
when it is pushed in and that no components on the
printed circuit board are damaged.
4. Make sure that the plugs of the multi connector strip
are inserted correctly. Then gently press in the module
completely. The locking levers will then lock automati-
cally (see diagram).
16 Festo SPC200-COM-CAN 0012NH English