MAXTOOLS JSL260 Manual De Instrucciones página 10

English
5. The jumper cable and its indicators have the following functions:
A. GREEN LIGHT ON: it indicates correct connection. You can jump start the engine.
B. RED LIGHT ON AND BEEPING: it indicates reversed polarity. Make sure the red clamp is
on the positive pole and the black clamp on the negative one.
C. GREEN LIGHT FLASHING AND BEEPING: it indicates low battery of the vehicle. Press
the "Boost" button and the green light will switch on. Jump start the engine within the
following 30 seconds.
D. LIGHTS OFF, NO BEEPING: it indicates that the battery of the vehicle is at 0V. Make sure
the polarities of the connection are correct. Press the "Boost" button and jump start the
engine within the following 30 seconds.
6. Turn the ignition key for a maximum of 8 seconds and then wait for a further 3 minutes
before attempting to jump start again.
7. When the engine is running, FIRST remove the cable of the device and then remove the
clamps from the battery poles.
Note: when pressing the "Boost" button on the jumper cable, the security function of the device is
inhibited. Once the engine has been jump started, the cables must be quickly disconnected from
both the starter and the battery in order not to dangerously overload the device.
Charging of cell phones and tablets
1. Connect the cable B set to the USB5V2A port.
2. Select the appropriate terminal and connect it to either the mobile phone or the tablet.
3. Press the push button of the device to start the recharge process.
10