Charging Instructions - MAXTOOLS JSL260 Manual De Instrucciones

INSTRUCTIONS FOR USE
Indicator
Press the button in order to check the charge state of the device.
Indicator Switched off
Charge level
One led at a time will flash in the indicator during recharge. Steady-on-lights indicate the
charge level. The indicator switches off once fully charged.

Charging instructions

1. Connect the 230V battery charger to the mains and then the connector to the 15V-1A
charging port.
2. Alternatively, connect the car charger to the cigar lighter socket and then the connector to
the 15V-1A charging port.
Emergency start
The jumper cable of the JSL260 is equipped with a special protection system as well as LED lights
for safer use.
1. The device must be properly charged, with at least four LEDs of the indicator switched on.
2. Firmly plug the blue connector of the jumper cable into the socket of the device. The cable
LEDs will not light up.
3. Connect the red clamp to the positive terminal (+) of the battery, or to the remote positive
pole. Connect the black clamp to the negative pole (-) of the battery or to the remote negative
pole.
4. The connection must be carried out with both sides of the clamp firmly attached to the
metal. In case of sulfurous deposits on the pole, these must be previously removed.
5 flashings
0% 10%
1 Led 2 Led
20% 40%
English
3 Led 4 Led
60% 80%
5 Led
100%
9