General Warnings - MAXTOOLS JSL260 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

GENERAL WARNINGS

1. Make sure that the blue connector of the jump start clamps is correctly plugged into the
device port. If this were not the case, performance would decrease drastically and the
plug might melt.
2. Both arms of the clamps must be well connected to the battery poles or to the remote
terminals. They must be free of rust, dirt or sulfates.
3. Pay particular attention to the contact surface of the clamps. Should it be too small, both
cables and clamps might overheat and the latter be damaged.
4. If jump starting proves particularly difficult, do not insist for more than 4/6 seconds and
make the jumper battery cool down for at least 5 minutes between one attempt and the
next.
5. If your car does not start after the third attempt, you need to let the device cool down
properly to avoid irreparable damage. Check for any further problem that might prevent
your car from jump starting.
6. Do NOT connect the two clamps together as this may cause sparks or fires.
7. DO NOT open the device to avoid fire risk.
8. Incorrect use of the device can irreparably damage the battery.
9. The guarantee does not apply to the battery as this is a consumable item.
10. The booster must always be recharged in well-ventilated places and away from
easily inflammable materials.
11. Non compliance with the above instructions may lead to serious damage of the unit.
Furthermore:
Always pay the utmost attention when using the appliance for engine jump starting
Keep out of children's reach
Do not keep in a humid place
Do not soak in water
Do not use in close proximity to inflammable liquids or in the presence of inflammable
gases
Any intervention must be carried out by authorized personnel only
Do not expose to heat sources
Battery charging must be carried out at room temperature and only by using the charger
provided
If the device is not used in compliance with the operational standards, leaking of fluids
may occur. Carefully avoid contact with eyes, skin and clothes. In case of contact with
eyes or skin, wash with plenty of water and seek medical advice
The device must be recycled under the current rules.
English
13

Publicidad

Tabla de contenido
loading

Productos relacionados para MAXTOOLS JSL260

Tabla de contenido