Yakima PowderHound SE Manual De Instrucciones página 3

LOAD YOUR SKIS OR BOARDS.
• Load ski tips
to the rear of your car.
• Load bindings between
the carriers.
If bindings are not touching the
roof, and carriers can close,
GO TO NEXT PAGE.
DO YOU NEED
MORE BINDING
CLEARANCE?
Install the SkiLifts for binding clearance, or if the
factory bar is arched and cannot align with carriers.
• Uninstall bolt and hex key on
either SnapAround.
FACTORY BARS:
Add a SkiLift to the hinged end of each carrier.
• Uninstall bolt and hex key on
farthest MightyMount.
1033296A - 3//12
ROUND OR SQUARE BARS:
Add a SkiLift to one end of each carrier.
• Attach SkiLift with bolt
and hex key.
• Attach SkiLift at hinged end of
carrier with bolt and hex key.
REAR
If the bindings touch the roof of your
car, install the SkiLifts (next step).
SKI LIFT INSTALLATION
Open the carrier (lift or push to release the latch).
• Attach another bolt and hex
key to SnapAround.
• TIGHTEN ALL HEX KEYS
• Attach another bolt and hex
key to MightyMount.
• TIGHTEN ALL HEX KEYS