Main Components - Stabila LAR-200 Instrucciones

USA
Operating instructions
The STABILA LAR-200 is designed to be an easy to use exterior rotating laser. Its
horizontal rotating and plumb point are self-leveling ( ± 5°) and fully automatic.
The LAR-200 has an operating range of 1000 ft ( 300m ) and includes a full function
receiver for long distance and bright light applications.
1.800.869.7460 U.S. and Canada

Main components

A
Splitter pentaprism SP:
SP1: vertical beam emission aperture
(1)
(2) SP2: rotation beam emission aperture
(3) ON/OFF switch
(4)
High alert/ automatic level On/Off
LEDs for displaying:
Red LED: low battery or laser overheat
(5a)
(5b) Green LED: Operating mode ON or READY / OK
(6)
Shock protection
Battery compartment cover
(7)
(8) 5/8" thread for connection to tripod
(9) 4 markings to create a plumb-line laser function
(10) Housing:
designed for exterior use: dust and water protected.
Not submergeable ( IP65 )
2
NB:
This is a class IIIa laser.
Do not look directly into the laser beam !
Keep this product away from children !
The goggles available for these units are
not safety goggles. They enable you to see
the laser beam more clearly in bright light
conditions.
Main applications:
Leveling
Set the laser unit on a firm base or a tripod.
T T i i p p : : For the most accurate and efficient measuring it is
best to set up rotating lasers towards the center of your
work
Press the button (3), to turn on laser unit. The laser unit
will level automatically. When the unit has self-leveled,
the laser will rotate automatically. Depending on the
surrounding light conditions, you can either use the
laser beam directly in low light conditions ( always mark
the center of the dot) or use the included receiver in
bright conditions.
Please note that the center of laser dot is marked!
Operating modes:
Using - Automatic leveling with high alert mode
For protection, the rotating laser turns itself off completely when in this high alert
mode!
The laser unit can be turned on by briefly pushing button (3). The laser will now
level automatically. The green LED (5b) lights up and the LED (4) begins to flash.
When the laser spins, it is now level. At this point the LED (4) will continue to flash
for approximately 30 seconds giving the user time to position the laser unit in
desired position. E.g. to adjust height or set on tripod, etc.. During this 30 second
period, the laser unit will compensate for minor movements and re-level. After this
30 second period the LED (4) light will go out and the laser unit will switch to high
alert mode .
3
3
3
4