Before Use - BVA Hydraulics J22910 Manual De Instrucciones

BEFORE USE

1. Verify that the product and the application are
compatible, if in doubt call Technical Service (888)
332-6419.
2. Before using this product, read the operator's manual
completely and familiarize yourself thoroughly with
the product, its components and recognize the
potential hazards associated with its use.
3. Replace worn or damaged parts and assemblies with
factory authorized replacement parts
as instructed in Maintenance Section.
4. Use adequate eye protection when operating or near
this equipment.
*Air Actuated
Hydraulic Pump
Air Supply Inlet
(*) Items not included with unit
only. Lubricate
*Hydraulic Connections
i.e. Couplers and fitting
(3/8"-18 NPTF)
Figure 2 - Typical Installation Illustration
3
SET UP
(Refer to Figure 1 & 2)
1. Remove the plug on oil port, connect 3/8" NPTF
hydraulic connection to oil port, i.e. coupler, hydraulic
hose, fitting etc. Ensure the oil ports and thread
connections are clean before connecting to the
hydraulic system.
NOTE: Always secure threaded connections with non-
hardening pipe thread compound. Take care not to
introduce compound into port orifices. Tighten securely
to prevent accidental removal of components while in
use.
2. Connect the hydraulic connection to hydraulic pump.
3. Install a pressure gauge to monitor the system
pressure.
WARNING: DO NOT exceed rated pressure of
!
10,000 psi.
*Hydraulic Hose
Bead Breaker