Finishing The Installation; Using Your Ceiling Fan - Fanaway LD-0003-16 Serie Instrucciones De Instalación

Fanaway Classic Installation Instructions

FINISHING THE INSTALLATION

Slide and align the canopy up to the mounting bracket. Ensure all electrical wiring is tucked inside the
canopy and that the wires are not damaged during this step. Secure the canopy to the hanger bracket
using the screws provided.
Fig. 12

USING YOUR CEILING FAN

SETTING DIP SWITCHES
When two or more fans are located near each other, you may desire to have the receiver/transmitter for
each fan set to a different code, so that the operation of one fan does not affect the operation of the other
fans.
The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the
transmitter are in the battery compartment. Fig. 13.
NOTE: Ensure that the power to the supply wires has been turned off before setting the code.
Fig. 13
Fig. 14
Change the position of the DIP switches in the remote transmitter and the receiver. Make sure that the
DIP switches match in the remote receiver and transmitter. If they don't match, the transmitter will not
function. Fig. 14
9 | P a g e L D - 0 0 0 3 - 1 6 / X X X / 0 1