Inserting Batteries - REVELL Control RTF Aquila Manual De Usuario

Ocultar thumbs

Contenido

Idiomas disponibles

HELICOPTER

LiPo battery

CONTROLLER

Starting position

Note: Before turning on

the controller, the throttle

stick must be in the down

position.

Antenna

Throttle stick

ON/OFF

switch

1. To open the battery cover,

slide it downwards.

Note: Before recharging and after every ﬂ ight, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage. Never leave the helicopter unattended when recharging.

1. Turn off the helicopter and the controller (pic. 1).

2. Separate the red connectors on the ﬂ ight cable on the helicopter (pic. 2).

3. Carefully connect the red connector to the cable of the 220 V AC adapter (pic. 3).

Do not force.

4. Plug the 220 V AC adapter into a mains socket. Charging will now commence.

5. The charging process is complete when the charger's LED indicator comes on.

Disconnect the battery from the charger immediately.

The helicopter can be ﬂ own for about 8 minutes after

approximately 90 minutes of charging.

The battery should not need longer than 100 minutes to charge. If the charging status indicator does not come on after this time, stop the charging process. See if the helicopter works, and if so, ﬂ y it until the

battery runs down completely. Then repeat the charging process described above.

Aquila_Anleitung 04_180609.indd 6

Helicopter and Control

Helicopter and Controller

Coaxial rotor system

Landing gear

Battery cover

Power ON/OFF light

Direction stick

(left, right, forward

and backward)

Right/left trim buttons