Laser 6291 Manual Del Usuario página 4

Introduction
Engine Timing Tool Kit Ford 1.0 litre 3 Cylinder EcoBoost with VCT
Specifically designed for the new Ford 1.0lt 3 cylinder EcoBoost engines.
and used in conjunction with 6290 to assemble the VCT (Variable Camshaft Timing) units on
the camshafts in their TDC position without play.
Required to align the VCT units when they are assembled on the camshafts.
The information given below is for reference only.
The Tool Connection Ltd recommends the use of Manufacturer data or Autodata.
The Tool Connection cannot be held responsible for damage to engine or personnel whilst
using this tool kit.
Model Model
Ford B-MAX
C-MAX
EcoSport
Fiesta
Focus
Grand C-MAX
Grand Tourneo Connect
Tourneo Connect
Transit Connect
Transit Courier
Plan Layout
Ref Code OEM Number
A C706 303-1606/1
B C707 303-1606/2
www.lasertools.co.uk
2
Type Year Engine Code
EcoBoost 2012 to 2015 M1JA
ECOnetic SFJA
SCTi EcoBoost SFJB
M1DA
M2DA
P4JA
P4JB
XMJA
XMJB
M1JE
M2GA
Description
VCT Locking Tool - Inlet
VCT Locking Tool - Exhaust
Instructions
Preparation
• Always refer to manufacturer specific data and instructions
• Turn engine to TDC No.1 cylinder before disassembly of engine
• Used with the front engine cover fitted.
Component Descriptions:
Components A:
Used to set up the Variable Camshaft
Timing pulleys (VCT).
The special tool set 6291 is used in
conjunction with 6290 engine timing kit
1
to assemble the VCT (Variable Camshaft
Timing) pulleys in to their camshafts at
TDC.
After assembly of the camshaft drive
belt, belt tensioner, front cover, oil seal
and crankshaft front pulley with the
crankshaft and camshaft still locked at
TDC fit components A & B as shown and
tighten bolts (1) to 10Nm. Turn the inlet
tool anti-clockwise and the exhaust tool
clockwise to remove any play. Tighten
the VCT fixings (2) to the correct torque
as described by OEM instructions.
See Fig.1 and 2.
N.B: refer to OEM data and information
for full instruction.
N.B. On engines equipped with VCT,
if the VCT pulleys require removal or
loosening ensure their initial position is
marked with chalk or paint.
www.lasertools.co.uk www.lasertools.co.uk
1
1
1
2
3