Installation Of The Appliance - Springer RQ Serie Manual Del Usuario E Instalación

INSTALLATION OF THE APPLIANCE

screw
screw
I M P O R T A N T
Build the framework, fixing the four parts. Put and fix the frame onto
the wall through 6 fixing points (3 upside and 3 downside)
- to detach the metallic base of the appliance, unscrew the
safety screw located on the right hand side lateral part of the same.
- join the two lateral beams to the base with a screw in each
lateral.
- fix the metallic set (base and beams) to the framework,
with three screws at the base and two screws at each lateral beam
NOTE: before resuming the installation, be sure that the
slope of the base is 0.5 blister (1 cm).
- slide the appliance on the metallic base all the way and
put the safety screw located in the straight lateral part of the appli-
ance back on.
- arrange the restraining foam to the lateral and upper parts
between the framework and the appliance to avoid air flow be-
tween the external and the internal environments.
- fix the molding on the wall to finish the installation proce-
dure.
1) Once the installation ended, confirm the slope of the ap-
pliance is correct.
2) To reduce the cable length:
- withdraw the plastic front by unscrewing the two screws
located in the upper part of the appliance
- adjust the cable length, arrange the remaining cable on
the back of the control panel
4