Springer RQ Serie Manual Del Usuario E Instalación página 5

drain
WALL INSTALLATION USING SPECIAL CONCRETE BOXES
INSTALLATION ON WINDOWS
- Put the plastic front back on by encasing first the lower part
and then the upper part
3) The unit comes out of factory with the cable arranged on
right hand side, but if you wish, it is possible to change it to the
other side. To do this, withdraw the plastic front, pass the cable to
the other side placing it in the lower part of the appliance, and clip
the plastic front on the labeled place.
4) Your appliance has a drainage for water to exit. Depend-
ing on the place of installation, you may use a hose connected to
the drainage net of your residence to avoid water dripping from
occurring.
5) In order to keep a normal air flow through the compres-
sor and condenser please verify that the lateral and superior open-
ings of the appliance are turn outward and TOTALLY cleared. Oth-
erwise, your appliance may present operation problems, with pos-
sible compressor failure. Very thick walls should be beveled out-
wardly.
- follow all the previous instructions
- verify if the slope of the appliance is correct (0,5 blister - 1 cm)
- leave lateral and upper openings so the air flow within the com-
pressor and the condenser is normal.
The installation on windows is recommended only in those
cases in which there is not any possibility of installing the appli-
ance on walls, since it can cause vibrations and noise. But, if it is
the only place available, follow these suggestions:
5