Supplies Required; Installation Instructions - Bradley S19-210FW Manual Del Usuario

Installation
Installation

Supplies Required:

• (3) 3 ⁄ " floor anchors and bolts
8
• Pipe sealant
• Piping to ½" NPT water supply inlet
• Piping to 1¼" NPT drain outlet
• Sign-mounting hardware
NOTE: Local codes may require the installation of
a backfl ow prevention valve to complete proper
installation. Compliance with local codes is the
responsibility of the installer. Valve must be tested
annually to verify that it is functioning properly.
Backfl ow prevention valves are not included with
the fi xture and may be supplied by the contractor
or purchased from Bradley Corporation.
Step 1: Secure base to floor
1.
Install three suitable anchors (supplied by
installer) for 3
2.
Bolt the base to the floor anchors using
bolts (supplied by installer).
Step 2: Assemble eye/face wash
1.
Assemble eye/face wash components as
shown on page 4
• Apply pipe sealant (supplied by installer) to
all male-threaded pipe joints.
• Use the rubber grip pad provided or a
strap wrench around pipes when tightening
to prevent marring the Bradtect®
protective, safety yellow coating. Place the
grip pad on the pipe, then put the wrench
over the grip pad and turn the pipe with
the wrench.
Step 3: Connect water supply
1. C
onnect the water supply piping (supplied by
installer) to the ½" NPT inlet on the eye/face
wash.
2. Connect the drain piping (supplied by
installer) to the 1¼" NPT drain outlet on the
eye/face wash.
3. Mount the safety sign to the wall using sign-
mounting hardware (supplied by installer).
Bradley Corporation • 215-155FW Rev. G; ECM 08-539
⁄ " bolts in the floor.
8
3
.
8 3 ⁄ "
8
(212mm)
⁄ "
8
36"
(914mm)
to Bottom
of Base
NOTE: All dimensions assume standard thread engagement.
Variations in manufacturing allow for +/-
threaded joint. To find the tolerance of a dimension,
add the number of thread joints in between a
dimension and multiply it by
15½" (394mm)
Ø 10"
(254mm)
5¼"
(133mm)
6"
(152mm)
1 ⁄ " (3mm).
8
6/9/09
S19-210FW
42 5 ⁄ "
8
(1082mm)
to Bottom
of Base
1 ⁄ " (3mm) per
8
3