Automatic Mode - GYS GYSDUCTION AUTO Manual Del Usuario

Translation of the original instructions
No-Load

Automatic mode

To start this mode:
Manual mode
To start this mode:
The manual mode allows to reach the maximum power of the Gysduction. At this power, workpieces can
heat up very quickly. The closer the inductor is to the workpiece, the higher the heating power will be.
Audible heating signal
To activate/deactivate this function:
Thermal protection indicator (8)
GYSDUCTION AUTO
If there is no part to be heated, or if the inductor is placed on a non-ferrous
metal, the « no-load »indicator (10) lights up when pressure is applied on one
of the heating controls.
With this mode, Gysduction adapts to suit the part to be heated (size-thick-
ness) and takes into account the distance between the part and the induc-
tor. It maintains a constant and optimal heating power, symbolised by the
OK zone (9) of the interface. With this mode, the GYSduction never heats at
maximum power.
Automatic mode is the default heating mode. If, however, the unit is set to
manual mode, briefly press the MODE button (7) until the LED in front of
"AUTO" (4) lights up.
Display :
The digital display shows the last % value used by the machine to maintain
a constant and optimal power according to the heating conditions. This
value corresponds to the settings that should be used in Manual mode to
obtain the same result with the same conditions. Thus, if the user considers
the heating recommended by the Gysduction too low or too high, he can
copy this value in the manual mode and vary it to reach the desired power.
In this mode, the user selects the desired heating power.
Briefly press the MODE button (7) until the LED in front of « MANUAL » (5)
lights up.
Operating : The digital display (2) shows the percentage of the maximum power (2400
W) that the inductor can transmit to the workpiece to be heated. Use the
setting buttons (1) to adjust to the desired power.
An audible BEEP can be activated to indicate heating activity. The BEEP
sounds as soon as the heating is effective and its frequency varies according
to the position of the inductor in relation to the part to be heated. The closer
the inductor, the higher the frequency.
Press the MODE button (7) for 3 seconds to activate/deactivate this BEEP.
This indicator lights up to indicate that the product has entered thermal pro-
tection due to overheating. As long as this light remains on, the product is
inoperative. It switches off when the product has cooled enough.
Heating can only be reactivated from this point on.
EN
17