Assembly Indications For Inverting The Doors - Arneg Pelican Manual De Instalacion Y Uso

Pelican
English

1. Assembly indications for inverting the doors

ATTENTION!: Cut off power supply to the cabinet before proceeding with all operations
Brema 5 - Brema LF refrigerated wall cabinet is normally supplied in the version with right-hand ope-
ning doors. If required, the direction of door opening can be inverted from right to left ..
N.B.Is not possible to invert one or more doors individually.
30 minutes are sufficent for this operation and the collaboration of 2 workers is recommended.
Equipment required:
Hammer - Spatula - Drill - Drill bit Dmax= 9mm - Pliers - Pliers for elastic rings - Hexagonal spanners 2/
3/4 - Cross-head Screwdriver - Metal pipe / spacer .
In order to invert the doors, follow the indications below:
1 Detach the spring-loading spanner from
its housing
2 A) Insert the spring-loading spanner into one
of the holes ofthe lower pin.
Insert the spring-loading spanner into one of
the holes ofthe lower pin.
B) Keeping the spanner still in the position
indicated, remove the spring-loading pin and
place both the pin and the spanner in a safe
place.
1 - Loading pin 2 - Spring-loading spanner
(1)
3 A) Remove the screws
that fix the wiring
protection plate in
place.
B) Pull out the cable.
C) Pull out the connector
D) Open the connector
4 (referred to the right and left-hand risers).
This phase applies both for dismantling
the right-hand door and for preparing the
left-hand rise.
A) Remove the side buffer profile using a
spatula
B) Pull out the cable and open the con-
nector
36
(2)
A
A
B
A
B
C D
B
05060104 01 01/09/2015