ABC Design Salsa 3 Instrucciones De Uso página 11

7. Fitting and removing the guard rail
a.
Fit the guard rail by inserting it in the plastic mounts on both sides.
b.
To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail
off away from the pushchair
8. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
9. Fastening the harness
a.
To fasten the harness, bring the top two plastic catches together and interlock them.
b.
Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct
10. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
11. Adjusting the seat unit
To adjust the seat unit, press and hold down the catches on both sides of the seat unit and adjust the
height of the seat. When you have reached the required position, let go of the catches to allow the seat to
remain in that position.
12. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again so that the handle will remain locked
in this position.
13. Folding the pushchair
To fold the pushchair, bring the handle to its lowest position as described in point 12, holding the button
(1) down as you do so.
Now rotate the knob (2) to the left and push the handle down.
Now you can fold up the pushchair.
Note: To unfold the pushchair, follow the instructions in point 1 "Opening the pushchair".
CAUTION: Ensure that all the catches are engaged before use.
14. Universal holder
a. The fittings for the Universal cupholder are located at the points indicated in the picture.
b. The universal fitting can hold ABC Design accessories, such as the ABC Design cupholder,
changing bag and parasol.
EN - 06