Mitsubishi Electric CITY MULTI PLFY-WP-VFM-E Serie Manual De Instalación página 18

6. Installing the grille
Fig. 6-17
A
Signal receiver
Fig. 6-18
18
A
Button
B
Vane motor
C
D
Connector
D
B
E
C
E
6.4. Locking the up/down airflow direction (Fig. 6-17)
The vanes of the unit can be set and locked in up or down orientations depending
upon the environment of use.
performed using the remote controller. In addition, the actual position of the vanes
may differ from the position indicated on the remote controller.
1
Turn off the main power switch.
Injuries and or an electrical shock may occur while the fan of the unit is rotating.
2
Disconnect the connector for the vane motor of the vent that you want to lock.
(While pressing the button, remove the connector in the direction indicated by
the arrow as shown in the diagram.) After removing the connector, insulate it with
tape.
Caution:
Do not set the up/down vanes passed the specified range. Condensation could
form on and drop from the ceiling, or the unit could malfunction.
6.5. Installing the intake grille (Fig. 6-18)
reverse order to install the intake grille and the corner panel.
A
Water piping of the main unit
B
Drain piping of the main unit
C
Corner panel
* Installation in any position is possible.
D
Position of the levers on the intake grille when sent from the factory.
* Although the clips can be installed in any of four positions.
E
Receiver (for SLP-2FAL*)
6.6. Check
and the surface of the ceiling. If there is any gap between the unit and the grille, or
between the grille and the surface of the ceiling, it may cause dew to collect.
check the connections.
sensor does not rotate, review the procedure in "6.3. Installing the grille".