BOND MANUFACTURING HYPH4601-10 Manual Del Usuario página 6

Gas connections on the appliance are leak
tested at the factory prior to shipment.Possible
mishandling of the appliance during the
shipment process might contribute to product
integrity as a whole.A complete gas leakage
test must be performed again at the installation
site.Please follow the procedure below for
leakage test.
Make a soap solution of one part liquid
-
detergent and one part water.The soap
solution can be
bottle,brush or rag.Soap bubbles will
appear where a leak is present.
Make sure the control knob is in the "OFF"
-
position (full disk=·) on the control panel.
Turn on the gas supply and check for
-
bubbles from
connections.Presence of bubbles means
that a leak path is present.
If a leak is present,turn OFF the gas supply
-
immediately,tighten
carefully,turn gas on again and recheck.
Never leak test while smoking,or near an
-
open flame.
INSTALLATION
Important safety requirements:
THIS APPLIANCE IS FOR OUTDOOR USE
ONLY
1.This appliance shall not be installed or used
indoors,in buildings,garages
enclosed area.
2.DO NOT place articles on or against this
appliance.
3.DO NOT use or store flammable materials
near this appliance.
4.DO NOT operate this appliance unless it is
fully assembled with reflector and protection
guards in place.
5.Installation and repair should be done by a
qualified service person.This appliance must be
inspected before use and at least annually by a
qualified service person.More frequent cleaning
may be required as necessary.It is imperative
that the control compartment,burners and
circulating air passages of the heater and light
be kept clean.
applied with spray
the hoses and
an leaking fittings
or any other
Step 1: Place the tank housing (A) horizontal,take out
the glass tube(C),and then attach the tank supporter to
the bottom of tank housing using the M6x20 screws
(N) ,M6 nuts (L) and washers (M) ,and make sure the
wing screw (K) is the same orientation with the door(H).
1-1
1 - 2
Step 2:
Screw off all M5x12 screws(I)
supports(E) first and then put through the burner
bottom and use the screws
housing.
2-1
6
from the upper
to the
to fasten them inside the tank