Check For Leaks - BOND MANUFACTURING HYPH4601-10 Manual Del Usuario

Step 2 – Install Cylinder on the
base.
Put the gas tank in the tank
■
sure the gas tank sits i n the tank supporter
completely.Turn the wing screw on the
outer part of tank supporter clockwise to
secure the gas tank tightly. Please see
Figure 2
Step 3 –Connect the Regulator
to the gas cylinder valve.
Turn the cylinder valve clockwise to close the
■
gas supply on the gas cylinder. See Figure 3
Screw Regulator Coupling clockwise by hand
■
only.Make sure it is fastened. See Figure 3
The cylinder connection device is CGA No.
791 Connection.
WARNING: Do not over bend the tube, and do
not let the tube touch a hot part or sharp edge.

Check for leaks

Warning:
Perform leak test outdoors only.
Never leak test when smoking.
Do not use a flame to check for leaks.
See Figure 4
■
■
■
■
■
housing .Make
Figure 2
Figure 3
NOTE:
Whenever gas connections are loosened or
removed, you must perform a complete leak test.
Figure 4
9
9