Battery Replacement - Martin System TT200 Manual Del Usuario

1.3 Attributing the collar to the remote
To have the remote controlling the collar, follow the instructions :
Hold the remote's red point (on the right side of the remote) against
the collar's point (engraved in on the front side), until the LED flickers
orange. Take the remote away from the collar and touch the «impulse»
key on the remote. The LED will flicker green to indicate the operation
has been successful.
1.4 Choice of stimulation level
The stimulation level has to be selected on the remote. When it's switched
on, the LCD screen indicates the previously selected level. To change the
level, touch the increasing arrow to increase, and the decreasing arrow
to decrease it. The levels are programmable from 0 to 9. The 0 level
sends only beep-sound, without impulse.
1.5 Choice of the program
There are four programs available on the remote.
• Simultaneous sound and stimulation (electronic impulse with a beep-
sound);
• Sound warning (beep-sound only when you touch briefly the impulse-
key, beep-sound followed 1 second later by an impulse if you hold your
finger on the impulse-key) ;
• Impulse without sound (impulse without any beep-sound) ;
• Only sound (only beep-sound, without any impulse).
16
To change the program, hold your finger on the «on/off-key» on the
remote. The LCD screen will display first a buzzer-symbol to indicate the
«simultaneous sound and stimulation» program ; then a buzzer with
an eggtimer-symbol to indicate the «sound warning» program; then no
symbol at all, to indicate the «impulse without sound» mode.
To use the «only sound» mode, select level 0 on the remote.
2. baTTERY REpLacEmENT
When the LED flickers red on the collar, or when the system doesn't func-
tion correctly (decreased range, no stimulation...), replace the batteries.
2.1 Remote control
Take off the cover by pushing with your thumb on the marked spot, and
slide it downwards. Extract the battery from the remote control by sliding
downwards. Enter a new battery respecting the polarities (+ upwards).
Clip the cover in the remote again. Use only CR2430 lithium 3V batteries.
2.2 collar
Unscrew the cover on the front side of the collar with a coin. Let the bat-
tery slip out by softly inclining the collar. Enter a new battery respecting
polarities (+ externally). Screw the cover pushing on the tight junction.
The collar switches on automatically when the cover is screwed. Use only
CR2 3V lithium batteries
EN
17