Kenmore 758.154200 Manual De Instrucciones página 7

SP6644 6/8/06 8:48 AM
Water Fill (continued)
Each water bottle is designed with an
"E-Z-Fill Side-Cap" that is easily
removable. Remove the "E-Z-Fill Side-
Cap" on the side of the water bottle by
twisting counterclockwise.
Place the opening of the water bottle
under a water faucet (the bottle should fit
under a four-inch clearance faucet). Fill
with recommended mixture of cold water
and Sears Bacteriostat #32-14900 (if
necessary) only. Solid debris could make
the valve leak.
Install the "E-Z-Fill Side-Cap" by twisting
clockwise. Hand tighten only.
Check for possible leaks by
performing the following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on the valve cap plunger for
about one second to let out a little
water.
3. Release the plunger.
4. Listen for air bubbles Look for leaks
around the "E-Z-Fill Side-Cap".
5. If you hear air bubbles or see leaks,
retighten the "E-Z-Fill Side-Cap" and
repeat Steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the unit
by grasping the water bottle handle and
lower it into the cabinet until the bottle
sits on pads at bottom of cabinet. The "E-
Z-Fill Side-Cap" must be facing the rear
of the cabinet. When positioned properly,
the plunger will open and water will flow
into the cabinet. The water level will
automatically remain at approximately
1/2" until the bottles are empty.
Allow the filter to saturate for 30 minutes
before operation.
Page 7
Pivoting Lid Removed for Clarity
7
Turn Counterclockwise
to Remove Cap
Valve Cap
Plunger
Raised
Section
t
R i g h
l e
B o t t