Filling Chain Oil Tank - Stihl HT 100 Manual De Instrucciones

If special chain lubricant is not available,
you may – in an emergency – use an HD
single grade or multigrade engine oil
with a viscosity that suits the prevailing
outside temperature.
Do not use waste oil!
Medical studies have shown that
renewed contact with waste oil can
cause skin cancer. Moreover, waste
is environmentally harmful!
Waste oil does not have the
necessary lubricating properties
and is unsuitable for chain
lubrication.
HT 100, HT 101, HT 130, HT 131
Filling Chain
Oil Tank
: A full chain oil tank is sufficient
for only half a tankful of fuel.
Check the oil level regularly
during cutting work. Never allow
the oil tank to run dry!
: Thoroughly clean the filler cap and
area around it so that no dirt can fall
into the tank.
: Position the unit so that the filler cap
faces up.
If the oil level in the tank does not go
down, the reason may be a problem in
the oil supply system: Check chain
lubrication, clean the oilways, contact
your servicing dealer for assistance if
necessary. STIHL recommends that you
have maintenance and repair work
performed only by a STIHL servicing
dealer.
English / USA
2
1
The bayonet-type oil tank filler cap with
its hinged grip can be opened and
closed without tools.
: To open the tank, swing the grip (1)
to the vertical position.
: Turn the filler cap counterclockwise
as far as stop and remove.
: Fill up with chain oil.
: To close the oil tank, place the filler
cap in position with the grip upright,
making sure the recesses (2) are in
alignment.
: Turn the filler cap clockwise as far
as stop.
: Fold the grip down so that it is flush
with the top of the cap.
23