Pre-Operation Checks; Install The Wheel Kit; Install The Support Leg - Firman RD9000E Manual Del Propietário

4. PRE-OPERATION CHECKS

Remove the Generator from the Shipping Carton
1. Set the shipping carton on a solid,flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold each side flat on
the ground to provide a surface area to install the wheel kit and support leg.

Install the Wheel Kit

[CAUTION]
The wheel kit is not intended for over-the-road use.
1.Before adding fuel and oil, tip the generator on it's side.
2. Slide the M10x125 wheel bolt through the washer, bushing and wheel.
3. Slide the bolt through the mount point on the frame.
4. Fasten securely with the M10 lock nut.
5. Repeat steps 2-4 to attach the second wheel.

Install the Support Leg

1. Attach the support leg to the generator frame with cap screws and nuts.
2. Tip the generator slowly so that it rests on the wheels and support leg.
Page 11