Assembly; Unpacking; Packing List; Tools Needed - Toro Powervac 51988 Manual Del Operador

Assembly

Unpacking

This product requires assembly.
Carefully remove the product and any accessories from

the box. Make sure that all items listed in the packing
list are included.
WARNING:
Do not use this product if any parts on the Pack-
ing List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product
that may have been improperly assembled could
result in serious personal injury.
Inspect the product carefully to make sure no breakage

or damage occurred during shipping.
Do not discard the packing material until you have

carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call

1-866-574-9242 (US) or 1-866-574-9243 (Canada) for
assistance.

Packing List

Blower
Upper Blower Tube
Sweeper Nozzle
Upper and Lower Vacuum Tubes
Vacuum Tube Screws (2)
Vacuum Bag Assembly
Vacuum Bag Adaptor
2-Cycle Engine Lubricant
Operator's Manual
Note: Read and remove all hang tags and store with your
Operator's Manual.
WARNING:
If any parts are damaged or missing do not
operate this product until the parts are replaced.
Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condi-
tion leading to possible serious personal injury.
Assembly
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug
when assembling parts.

Tools Needed

The following tool (not included or drawn to scale) is
needed for assembly:
Flat Head Screwdriver
Assembling and Disassembling Upper
Blower Tube and Sweeper Nozzle
See Figure 3 - 4.
1. Align raised tabs on main housing to the slots on upper
tube; slide together and tighten securely by twisting
until the tubes snap into the locked position. Check
tightness after initial run and retighten if needed.
NOTICE:
When correctly assembled, the tubes are dif-
ficult to separate. If they can easily be twisted
apart, the tubes are not locked. Continue twisting
together until the tubes snap into the locked posi-
tion. Tubes that are not fully locked together can
separate during blower operation.
2. Secure the sweeper nozzle and upper blower tube
together by aligning the raised locking tab on the upper
blower tube with the raised slot on the sweeper nozzle.
3. To disassemble, raise the locking tab with a flat head
screwdriver, rotate the tube and nozzle to unlock them
and remove from the main housing outlet.
Main Housing
Outlet
Raised
Locking Tab
Upper
Blower Tube
Sweeper
Nozzle
Figure 3
11