Starting And Stopping - Toro Powervac 51988 Manual Del Operador

WARNING:
Always shut off engine before fueling. Never
remove fuel cap or add fuel to a machine with
a running or hot engine. Make sure the unit is
sitting on a flat, level surface and only add fuel
outdoors. If the engine is hot, let the unit cool
for at least five minutes before adding fuel.
After fueling, immediately replace fuel cap and
tighten securely. Move at least 30 ft. from refu-
eling site before starting engine. Do not smoke
and stay away from open flames and sparks!
Failure to follow these instructions could result
in a fire and cause serious personal injury.
Ethanol-Blended Fuels
NOTICE:
Do not use E15 or E85 fuel in this product.
It is a violation of federal law and will dam-
age the unit and void your warranty. Only
use unleaded gasoline containing up to 10%
ethanol.

Starting and Stopping

See Figures 10 - 11.
To start a cold engine:
1. Set the blower on a flat, bare surface.
2. Slowly press the primer bulb 8 times.
Note: After the 8th press, fuel should be visible in the
primer bulb. If it is not, continue to press the primer
B
until you see fuel in the bulb.
Throttle
Trigger
Choke
Lever
Starter
Grip and
Primer Bulb
Rope
Operation
Stop
Switch
STOP
Figure 10
3. Place the choke lever in the FULL CHOKE position.
4. Pull throttle lock back to lock the throttle wide open.
5. Pull the starter grip and rope sharply until engine at-
tempts to run. Do not pull the starter grip more than
four (4) times.
6. Set the choke lever in the HALF CHOKE position.
7. Pull the starter grip and rope until the engine runs. Do
not pull the starter grip more than six (6) times.
Note: If the engine does not start, return to the FULL
CHOKE position and repeat steps 3 through 6 again.
8. Allow the engine to run for 20 seconds, then place the
choke lever in the RUN position.
Note: In cooler environments, additional pulls of the
starter handle may be required with the choke lever in
the FULL CHOKE position.
Full
Choke
B
Run
Position
To start warm engine:
1. Place the choke lever in the RUN position.
2. Pull throttle lock back to lock the throttle wide open.
3. Pull the starter grip and rope until the engine runs.
Note: If the engine does not start, repeat steps 3
through 7 again.
To stop the engine:
1. Press the stop switch to the stop (
engine will stop. The switch will automatically return to
the on (I) position when released.
B
Half
Choke
Figure 11
) position, the
STOP
15