Cleaning And Maintenance; Replacing The Bulb; Save Energy - Vestfrost Nordcap VT-408 Instrucciones Para El Uso

GB

Cleaning and maintenance

Cleaning
Before cleaning, disconnect the power
supply and remove all loose fittings.
The appliance is best cleaned using
warm water (max. 85°C) with a little mild,
perfume-free detergent. Never use cleaning
agents that scour. Use a soft cloth. Rinse
with clean water and dry thoroughly. It is
important to prevent water from entering the
control panel.
The sealing strip around the lid must be
cleaned regularly to prevent discolouration
and prolong service life. Use clean water.
After cleaning the sealing strip, check that it
continues to provide a tight seal.
It is recommended that the wire and tubular
condensers on the rear of the appliance be
cleaned.
The ventilation grille must also be kept free
of dust and dirt. Clean it with a vacuum
cleaner.
If the appliance is not to be used for any
length of time, switch it off, disconnect the
power supply, empty it, clean the inside and
leave the lid open to allow air circulation
and prevent smells.

Replacing the bulb

1. Disconnect the power supply by
removing the plug from the socket.
2. Remove the lamp cover by pressing it
together to release it from the two clips
(fig. 9).
3. Replace the bulb(s).
4. Refit the cover and reconnect the power
supply.

Save energy

- Keep the lid closed as much as possible.
- Check regularly that the lid closes tightly.
- Position the freezer in a cool (min. 5°C),
well-ventilated room.
- Defrost the freezer before the layer of ice
becomes excessively thick.
8
max.
15 W
fig. 9