Re-Fuelling; Cleaning; Maintenance Of The Stove Body; Trouble Shooting - FRANCO BELGE SAVOY 134 08 02 Manual Del Usuario

Poêle à bois

3.3. Re-fuelling

It is advisable to wait for the fire to be reduced to hot
embers before re-loading. The door should also be
opened slowly when re-loading.

3.4. Cleaning

It is essential to keep the grate free from a heavy build
up of ashes.
REMEMBER TO BURN SOLID FUEL CORRECTLY, AlR
SHOULD BE ALLOWED TO FLOW FROM THE ASH
PIT AREA THROUGH THE GRATE AND THROUGH
THE FUEL. IF THE GRATE OR ASH PAN ARE
C O N G E S T E D, T H E P E R F O M A N C E W I L L B E
EFFECTED .
If burning solid fuel, always empty the ash pan at least
once a day or whenever it is full of ashes. Never allow
the ashpan to overfill allowing ash to be in contact with
the underside of the grate. If this condition is allowed,
the grate will wear out pre-maturely.

3.6. Trouble Shooting

Problem
Fire difficult to start
Fire goes out
Fire burns too quickly.
Smokes when lighting up.
Smokes while burning.
Low heat output.
20
Probable causes
Wood green, too damp or poor quality.
Logs are too big.
Air starvation.
Insufficient draught.
Too much draught.
Excessive draw.
Poor quality wood.
Flue duct is cold.
Room is in decompression.
Draught is insufficient.
Down draught.
Room is in decompression.
Incorrect Fuels.
Document n° 955-1EN ~ 25/11/1998
"SAVOY"

3.5. Maintenance of the stove body

• The stove must be regularly cleaned.
• Remove all deposits from the combustion chamber
and clean the grate area.
• The vitro ceramic glass can only be cleaned using a
soft cloth and stove glass cleaner, available from your
Franco Belge Dealer. DO NOT USE ABRASIVES
• The vitro ceramic glass resists a temperature of
750°C. If the glass should be broken, it is recommended
that only an original factory replacement should be
fitted.
For enamelled finishes, the stove body can be cleaned
using a soft cloth either dry, or slightly damp with a very
mild detergent.
NEVER CLEAN ENAMEL SURFACES WHILST THE
STOVE IS HOT.
The cast iron body panels of non-enamelled stoves can
be cleaned with a proprietar y stove cleaner or
re-sprayed / touched up using a stove paint. These
products are available from your Franco Belge Dealer.
þ
: This sign means that you should
asked for a qualified engineer to do the
Action
- Use the recommended fuel.
- To light the fire, use small, very dry twigs. To maintain the
fire, use split logs.
- Open lower spin wheel and top air control lever.
þ
- Check that the flue is not obstructed, sweep it if
necessary
- Seek advice from a chimney specialist.
- Ensure that the lower spin wheel is closed
- Partially close the top air control lever.
þ
- Install a draught stabiliser. Consult your Dealer.
- Do not continuously burn small wood, sticks, bundles,
carpentry offcuts (plywood, pallets), etc.
- Burn paper and kindling wood to increase heat.
- In houses equipped with mechanical ventilation, partly
open a window until the fire is well established.
þ
- Consult a chimney specialist.
- Check that the flue is not obstructed, sweep if necessary.
þ
- Install an anti-down draught cowl. Consult your Dealer.
þ
- In houses equipped with Mechanical Ventilation, an
outside air intake must be installed for the chimney.
- Use the recommended fuel.
Réf. : 134 08 02
work.
Notice de référence