Glass Cooktop - Haier QSS740 Manual Del Usuario

CARE AND CLEANING

GLASS COOKTOP

Normal Daily Use Cleaning
ONLY use ceramic cooktop cleaner on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of your glass cooktop,
follow these steps:
1. Before using the cooktop for the first time, clean it with
ceramic cooktop cleaner. This helps protect the top and
makes cleanup easier.
2. Before using the cooktop for the first time, clean it with
ceramic cooktop cleaner. This helps protect the top and
makes cleanup easier.
3. Shake the cleaning cream well.
Apply a few drops of ceramic
cooktop cleaner directly to the
cooktop.
4. Use a paper towel or non-
scratch cleaning pad for ceramic
cooktops to clean the entire
cooktop surface.
5. Use a dry cloth or paper towel to
remove all cleaning residue. No
need to rinse.
NOTE: It is very important that you DO NOT heat the
cooktop until it has been cleaned thoroughly.
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you use
scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Spread a few drops of ceramic cooktop cleaner on the
entire burned residue area.
3. Using a cleaning pad for ceramic cooktops, rub the
residue area, applying pressure as needed.
4. If any residue remains, repeat the steps listed above as
needed.
5. For additional protection, after all residue has been
removed, polish the entire surface with ceramic cooktop
cleaner and a paper towel.
Use a non-scratch cleaning pad for ceramic cooktops.
18
Heavy, Burned-On Residue
1.
2.
3.
4.
Ceramic
Cooktop
Cleaner
Clean your cooktop after
are available through our Parts Center. See the Accessories and
each spill. Use ceramic
cooktop cleaner.
Metal Marks and Scratches
1.
2.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
Allow the cooktop to cool.
Use a single-edge razor blade scraper at approximately a
45° angle against the glass surface and scrape the soil. It
will be necessary to apply pressure to the razor scraper
in order to remove the residue.
After scraping with the razor scraper, spread a few drops
of ceramic cooktop cleaner on the entire burned residue
area. Use a non-scratch cleaning pad to remove any
remaining residue.
For additional protection, after all residue has been
removed, polish the entire surface with ceramic cooktop
cleaner and a paper towel.
The ceramic cooktop scraper and all recommended supplies
Consumer Support sections at the end of this manual.
NOTE: Do not use a dull or nicked blade.
Be careful not to slide pots and pans across your cooktop.
It will leave metal markings on the cooktop surface.
These marks are removable using the ceramic cooktop
cleaner with a non-scratch cleaning pad for ceramic
cooktops.
If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
49-2000682 Rev. 0