Inserting Batteries - EQUATION TH50DPGRF Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
INTRODUCTION
The room thermostat turns the heating system on and off to obtain the desired temperature (set
FR
temperature). It detects the air temperature and compares it with the set temperature. If the room
temperature is lower than the set temperature, the thermostat turns on the boiler, and turns it off when
the set temperature is reached, and so on.
ES
Energy effi ciency is ensured by a self learning TPI control algorithm, which adapts to the environment
and provides tight temperature regulation with minimal energy consumption.
PT
To obtain an optimum setting, set a low temperature (18°C for example) and increase degree by degree
each day to reach the temperature that suits you (comfort temperature).
The thermostat does not aff ect the power of the boiler, so there is no need to set a higher temperature
IT
to heat faster.
If the radiators have valves (manual or thermostatic) make sure that the radiators located in the same
room as the thermostat are open.
EL
The thermostat is compatible with modulating boilers, but with a reduction in performance. It is com-
patible with fl oor heating system if included in a full system by a specialist (hot water control should be
managed by another system)
PL
The Thermostat communicates wirelessly to the Receiver Box which is wired to the boiler. If the Ther-
mostat loses wireless communication or becomes faulty, the boiler can be switched on or off manually
using the button on the Receiver Box.
UA
INSTALLATION
RO
The thermostat must be placed, or fi xed on a wall, away from any source of heat (fi replace, radiator, sun)
and drafts (window, door), at a height of 1.2 m to 1.5 m.
EN
The receiver box must be connected to the inputs for a "ON/OFF" remote thermostat (T1 and T2) of a
boiler, regardless of the polarity, and on a 230V ~ 50-60Hz power supply. It is important to connect phase
(L) to terminal L of the receiver.
The Thermostat and Receiver Box in this pack are pre-bound.
The installation must be carried out by a person possessing the required qualifi cations while respecting
the national wiring standards in force.

Inserting batteries

1 - Push the cover of the battery compartment in the direction of the arrow in order to remove it.
2 - Insert 2 AA (LR06) 1,5V batteries in the compartment. Make sure you observe the right polarity ("+" and "-").
3 - Place the cover of the battery compartment back.
Important !
• Do not let children play with batteries
• Do not ingest batteries
• Non-rechargeable batteries are not to be recharged;
• Diff erent types of batteries are not to be mixed;
• New and used batteries are not to be mixed;
• Batteries are to be inserted with the correct polarity;
• Exhausted or leaking batteries are to be removed from the
appliance and safely disposed of;
• If the appliance is to be stored unused for a long period, the batte-
ries should be removed;
• The supply terminals are not to be short-circuited;
• The batteries must be removed from the appliance before it is scrapped.
78

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido