Troubleshooting - EQUATION TH50DPGRF Manual De Instrucciones

TROUBLESHOOTING

Operation issues are often due to minor causes; please go over the table below before contacting the
After-Sales Service. This could save you time and spare you unnecessary expenses.
Problem
No Display
The symbol is displayed
The symbols and
fl ashing
The symbols and
displayed
The symbols and
fl ashing
In case of persistent problem, please contact the after-sales service of your store.
Warranty
The warranty does not cover problems related to improper installation, incorrect wiring or improper use.
Binding / Rebinding
The binding operation described below is required if:
• Any of the system components (Wireless Thermostat or Receiver Box) are replaced.
• The Receiver Box has incorrect or no binding data stored (e.g. when pre-bound system pack compo-
nents have been mismatched).
During the binding procedure keep approximately 1m distance between the Wireless Thermostat and the
Receiver Box.
1 - Press and hold the Receiver Box push button for 15 seconds to reset
any previously stored data.
2 - After 5 seconds the red LED will start to fl ash quickly, but continue
to hold the button.
3 - After 15 seconds the red LED will change to fl ash slowly. Release
the push button.
4 - Press and hold the Receiver Box push button for 5 seconds to
enter the binding mode. The Red LED will start fl ashing quickly to
confi rm the binding mode has been entered.
Causes, solutions
Check batteries by opening cover.
Check that batteries are placed in the correct position.
Replace the batteries.
The batteries are getting weak.. (less than 10% capacity)
are
Replace batteries immediately
The sensor is faulty, contact your installer.to repair or replace
are
the thermostat.
Wireless signal is lost
are
Move the Thermostat to another location
Perform a rebinding
FR
ES
PT
IT
EL
PL
UA
RO
EN
1
15s
4
5s
85