U.S. And Metric Modes; U Sing The S Cale M Aster C Lassic; Adjusting The Wheel - Calculated Industries Scale Master Classic 6020 Guia Del Usuario

[RESET]
Used to clear the display. When pressed together
with another key, clears the value of that key.

U.S. and Metric Modes

The Scale Master Classic is set up to use U.S.
scales by default. The Scale Master Classic can
be set up to use Metric scales by performing the
following steps:
1) Remove the battery door on the back of the
Scale Master Classic and remove batteries.
2) Flip the switch from IMP
(U.S. /Imperial mode)
to MET (Metric mode).
3) Replace the batteries and
battery door before using
the Scale Master Classic.
While in Metric mode,
will remain lit in the display.
MET
U
sinG The

Adjusting the Wheel

The Celcon® polymer wheel can be adjusted
for each user's preference.
To adjust the wheel, take
a small, flat-head jeweler's
screwdriver and slightly
rotate the screw located
near the wheel tip. Rotating
the screw about 1/4 to 1/3
turn should be sufficient. Rotating the screw
s M
Cale
Metric
Mode
C
asTer lassiC
Rotate to Adjust Wheel
3 – User's Guide
U.S.
Mode
(Cont'd)