Cleaning Techniques - All-Power 1800PSI Manual Del Usuario

Operating Instructions

Cleaning Techniques

When cleaning with the pressure washer, some cleaning tasks can be solved with water alone, but for
most tasks it is advantageous to use a detergent. A detergent ensures a quick soaking of the dirt
allowing the high-pressure water to penetrate and remove the dirt more effectively.
The low-pressure position provides a gentle application of detergent. This position is also
recommended to rinse a surface after wax application or for other applications which require the
low-pressure of a garden hose. Low-Pressure is the equivalent of a garden hose set at the lowest
output to properly apply detergent. For detergent application, slide collar according to Figure 7.
Application of Detergent
1. Apply the solution to a dry work surface.
Note: Wetting the surface first is not recommended, as it dilutes the detergent and reduces
its cleaning ability.
On a vertical surface, apply horizontally from side to side starting from the bottom to avoid
streaking.
2. Allow detergent to remain on the surface for a short time before rinsing.
Caution: Damage may occur to painted surface if chemical is allowed to dry on the
!
surface. Wash and rinse a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
3. Rinse with clean water under high-pressure. On a vertical surface, first rinse from the bottom up,
then rinse from the top to the down. Hold nozzle 6 to 8 frame, the work surface at a 45° angle using the
flat spray as a peeling tool rather than a scrub brush.
Note: Insure that the chemical injection system is completely clean to switching from one
detergent to another.
Application Pressure Washer Liquid Vehicle Wax.
1. Immediately after cleaning, apply pressure washer liquid wax using low-pressure. Pour wax into
detergent solution reservoir.
2. Apply the wax sparing in an even layer. Apply to wet surfaces from the bottom up for even
distribution and to avoid streaking.
3. Rinse off the surplus wax.
Note: If surplus wax is not removed a hazy finish may result.
4. Wipe dry to reduce water spotting.
13