Operation Instructions; Start Up Procedure - All-Power 1800PSI Manual Del Usuario

Operating Instructions
Warning: Risk of injection injury. Do not direct discharge stream at persons or animals.

Start up Procedure

1. Make sure water supply is connected and turned on.
2. Make sure the unit is plugged in.
3. Release gun safety if locked. (See Figure 3)
A.
4. To allow air to escape from hose, squeeze trigger on the gun until there is a steady stream of
water.
5. Remove any dirt or foreign matter from the gun outlet and the male connector of the wand.
Note: Make sure the wand is locked.
Warning: If the wand is not securely locked into place. It could be ejected under high
pressure when operating the gun, possibly causing injury or damage.
6. Squeeze trigger on the spray gun.
7. Press the on/off button to start pressure washer. (See Figure 4)
ON
OFF
A. Safety lock "locked"
B. Safety lock "unlocked"
9
B.
Fig. 3
Fig. 4