Operation Controls - Promaker PRO-PL1300 Manual Del Usuario

a) Maintain a firm grip on the
power tool and position your body
and arm to allow you to resist
kickback forces. Always
auxiliary handle, if provided, for
maximum control over kickback
or torque reaction during start-
up. The operator can control torque
reactions or kickback forces, if
proper precautions are taken.
b) Never place your hand near
the rotating accessory. Accessory
may kickback over your hand.
c) Do not position your body in the
area where power tool will move
if kickback occurs. Kickback will
propel the tool in direction opposite
to the wheel's movement at the point
of snagging.
d) Use special care when working
corners, sharp edges etc. Avoid
bouncing and
accessory. Corners, sharp edges or
bouncing have a tendency to snag
the rotating accessory and cause
loss of control or kickback.
e) Do not attach a saw chain
woodcarving blade or toothed
saw blade. Such blades create
frequent kickback and loss of
control.
use
snagging the
ADDITIONAL SAFETY INSTRUCTIONS
FOR POLISHING OPERATIONS
Safety Warnings
Polishing Operations
a) Do not allow any loose portion of
the wool bonnet or its attachment
strings to spin freely. Tuck away or
trim any loose attachment strings.
Loose and
strings can entangle your fingers or
snag on the workpiece.
OPERATION
INSTRUCTIONS
1. Wool bonnet
2. Flange nut
3. Rubber pad
4. Wrench
5. Side handle
6. Trigger lock
7. Trigger
8. Cord guard
9. Speed level
10. Lock button
Specific
spinningattachment
CONTROLS
for
&
7