Promaker PRO-PL1300 Manual Del Usuario página 8

·Installing the side handle
The side handle should always be
used during operation.
Screw the handle into the top, left
and right of the Polisher housing. It's
determined by your need.
·ON-OFF Switch
1. Pressing trigger (7) while moving
trigger lock (6) forward to turn "ON"
the tool. And moving trigger lock
forward again, the trigger will locked.
2. Press trigger (7) again to turn the
tool "OFF".
·Mounting And Dismounting The
Wool Bonnet
(1) Insert the washer nut through the
rubber pad and thread it onto the
spindle.
(2) While holding the spindle with the
stop pin (10). Turn the washer nut
clock wise with accessory wrench
to screw it onto the spindle. Ensure
that the washer nut is thoroughly
tightened by using wrench.
(3) Wrap the rubber pad with the
hood of the wool bonnet and firmly
secure it by tightening and trying
its draw string. Be surethe excess
string is firmly rucked inside the
wool bonnet to prevent ittrom flying
out while polishing.
CAUTION: Improper fitting of the
wool bonnet may cause vibration.
(4) To remove the wool bonnet follow
the above procedures in reverse.
·Applications
1. Polishing varnished surfaces of
wooden furniture, etc.
2. Shining synthetic resin or ebonite
products.
PRACTICAL ELECTRIC POLISHER
APPLICATIONS
When utilizing this tool as a polisher,
set the speed to a lower speed for
maximum efficiency.
(1) Curved surfaces as well as flat
surfaces can be efficiently finished.
Do not excessively
push the polisher
surface of the material. The weight
of the polisher alone is sufficient
for effective polishing. Excessive
pressure will result in a poor finish
and cause possible overload to the
motor.
(2) Sanding disc polishing compound
or wax should be selected in
accordance with the material and
the desired surface finish. Maximum
polishing compound and /or wax.
Apply a small quantity of compound
and /or wax on material surface and
polish with the wool bonnet.
MAINTENANCE
Before cleaning or performing
any maintenance,
supply shall be disconnected
from tool.
All maintenance should only be
carried out by the manufacturer or
authorized service organization.
against the
power
8