Publicidad
7b
Turn the top cable spool screw counter-clockwise one
additional turn.
The tilting link should now be visible extending slightly at the
center slot opening.
7c
Check rotation of the lever.
If the lever does not rotate, turn the bottom cable spool screw
counter-clockwise 1-2 turns. Then, repeat rotation of the lever.
Both latches should be released.
7d
Check bottom latchbolt.
•
The bottom latchbolt should be flush with the bottom of the
door, or may extend not more than Z\," past the bottom surface
of the door.
•
If the bottom latchbolt extends more than Z\," past the bottom
surface of the door, adjust the bottom cable adjustment
screw clockwise until the latchbolt is flush or not more than
Z\," past the bottom surface of the door.
Adjust bottom
cable adjustment
screw if necessary
8
Lock the latch(es)
Lock (extend) the top latch by hand. If applicable, the bottom latch
should also lock.
Pull the top
latch as shown
to lock.
Latch locked
For 2-point latch only:
Check the bottom latch to be sure it is extended. The bottom
latchbolt should extend >\znʺ past the bottom door surface.
Additional adjustment of the bottom latch is described in later
steps.
Bottom latchbolt
While turning the lever, tape the bottom latchbolt to the door flush
with the bottom of the door.
>\zn"
reference
10
Publicidad
Capítulos
