Start And Stop Procedure; Operating Instructions - Altrad Belle RPC 60/80 Manual Del Operador

Hatz Diesel Engine (Electric Start)
2. Turn start key to position 'II'
remain in this position during operation. The battery charge and oil pressure warning lights
musst go out immediately after starting. Indicator light '1' is on when the engine is in
operation.
CAUTION
6. Always turn the start key back to position '0' before re-starting the engine. The repeat lock prevents the starter motor from
engaging and possibly being damaged whilst the engine is still running.
7. Move speed control lever to '1' back to the STOP position.
STOP direction. Hold it there until the engine has stopped.
10. Turn the key to the 0 position and pull it out. The lights must then go out.
• Take the compactor to where it is required.
• Having carried out the checks listed in the 'Pre start' section, you may start the engine.
the gearbox.
should be set to maximum.
• Set the throttle to maximum and use the control handle for direction and to steer or turn the compactor.
During normal operation you should not have to push the compactor but allow it to travel at its own pace.
The speed of travel will be determined by the condition of the surface being compacted.
Caution must be used when operating the compactor in reverse. Ensure that there are no obstructions or trip hazards when
operating in reverse.
compactor's weight. Work up and down a slope not across.
• Work the compactor over the surface in an organised pattern until the required compaction has been achieved.

Start And Stop Procedure

Never operate the electric starter when the engine is running or coasting to a standstill. There is a risk of
broken starter pinion or ring gear teeth.
Never stop the engine by moving the decopression lever. During breaks in work or at the end of the
working period, keep the starting handle and starting key in a safe place, out of reach of unauthorised persons

Operating Instructions

22