PLYMOVENT MiniMan-100 Instrucciones Para El Uso página 10

7. If you have purchased a halogen lamp cartridge (HL-20/24-100), please continue to follow the step by step instructions.
8. Remove the mesh(a) from inside of the hood. The most
efficient way to do this is to grab the mesh with a set of pliers
and pull it straight out. Also remove the sticker covering the
accessory holes on the hood(b).
9. Screw the switch assembly(a) to the hood with the supplied
nut and bolt(b). Push the plug that is attached to the lamp
cartridge(c), from the inside of the hood through the rectangular
hole.Fit light cartridge(d) inside of hood. Connect the plug from
the switch assembly to the plug from the light cartridge.
Excess of cable between switch assembly and light cartridge can
be stuffed back into the switch assembly housing.
10.Secure the power supply cable to the arm using two of the supplied plastic
fasteners(a). While doing this make sure that the length of cable between the
tube and hood(b) is long enough not to obstruct the movement of the hood.
Attach the rest of the cable to the arm with the remaining plastic fasteners and
the self adhesive anchors . you have now completed the installation
of the halogen lamp kit.
021213/0 MiniMan-100
A
B
D
A
B
C
A
B
EN - 9