General Instructions; Important Safety Instructions - T&S B-7000 Serie Instrucciones De Instalación Y Mantenimiento

General Instructions

Important Safety Instructions

DANGER: Immediate hazards which will result in severe personal injury or death.
WARNING: Hazards or unsafe practices which could result in severe personal injury
or death.
CAUTION: Hazards or unsafe practices which may result in minor personal injury or
product or property damage.
WARNING: Failure to read, understand or follow these instructions could lead to
hazards or unsafe practices which could result in severe personal injury or death.
CAUTION: Do not utilize chemicals in the hose &/or the reel. Chemicals can cause
premature failure of the hose &/or the seals.
CAUTION: Operators need to be instructed on the safe, proper use and maintenance
of this product. Keep this manual for future reference. Hazards or unsafe
practices may result in minor personal injury or product or property damage.
TOOLS: (a) wrench: 10mm, 13mm, 16mm & 19mm; (b) nut driver: 8mm and 10mm;
(c) needle-nose pliers (d) cross-recess screw driver #2, and (e) external retaining ring
pliers. B-7102 models include a fl at wrench.
Installation
MOUNTING
Reels complete with hose come set at proper tension and are ready to install. (Fig. 1)
Fixed base of reel allows mounting in several diff erent positions including wall mount,
base down, or base up. If moving guide arm, three nuts (17mm SS or 19mm painted)
on side of reel must be removed. If reel is enclosed version, remove and mount base to
surface, then attach reel to base.
MOUNTING B-7102
The B-7102 mounting fl ange is part of the support frame. This hose reel can be
positioned as wall mounted (as shipped) or base up. To convert from one position to
another:
• Temporarily clamp unit to a work surface. Remove all tension from reel; see "Tension
Adjustment. "
• Slide fl at wrench provided between spool assembly and support frame onto shaft to
hold it from turning during the next step.
• Loosen but do not remove the shaft nut (22mm hex) until the shaft is free to turn in
the support frame hole.
• Remove the (2) screws securing the hose guide bracket, move the bracket to the
desired location and reinstall the screws.
• Turn the spool and shaft relative to the support frame until the hose fi tting at the
formed metal tube assembly is parallel with the hose guide bushing centerline.
• Retighten the shaft nut. Re-tension reel (see "Tension Adjustment")
5