Publicidad
Idiomas disponibles
Idiomas disponibles
Description of console functions
Before using any other function, change the
access code (function CHANGE ACC. CODE), since
the 4 last digits of the access code determine the
YYYY installer code of the console and the different
encodings.
ERREKA
AUTOMATION
ACCES CODE
-
ACCES CODE
******
ACCES CODE
****** CODE OK
ENCODE TRANS.
encode memory
ENCODE MEMORY
display memory
DISPLAY MEMORY
copy memory
COPY MEMORY
replace trans.
REPLACE TRANS.
change acc. code
CHANGE ACC. CODE
see trans. code
SEE TRANS. CODE
see memory code
SEE MEMORY CODE
standard transm.
STANDARD TRANSM.
standard memo.
STANDARD MEMO.
................
enter
9
9
9
9
9
enter
enter
I253DEN
Function ENCODE TRANS.
This function can be used to programme personalised
or standard (non-personalised) transmitters with a
single installer code. It can be used to programme the
t r a n s m i t t e r s w i t h t h e i n s t a l l a t i o n n u m b e r
(INSTALL.NO., ZZZZ) and the transmitter code
(TRANS. CODE ?, XXXX). Press Ä to programme the
transmitter serial number.
If only the first two figures of the access code are
changed, leaving the other four unchanged (**9999),
the standard ROLLER transmitter code cannot be
modified.
9
Function ENCODE MEMORY
This function is used to programme personalised or
standard (non-personalised) memories with a single
installer code. It can be used to programme memories
with the installation number (INSTALL.NO., ZZZZ),
after which it assigns the installer code and the
installation number and then checks the memory card.
If it is correct, the message MEMORY OK is displayed
while waiting for a key to be pressed: press Ä to leave
the main menu; press Ö to programme or pre-assign
transmitter codes and the channel to be used. To
programme the transmitter codes, enter the first
transmitter code and the last transmitter code (in four
digit format, XXXX).
If only the first two figures of the access code are
changed, leaving the other four unchanged (**9999),
the channel and transmitter codes are not programmed
or pre-assigned (only the installer code-memory
installation number is changed). In this case the codes
should be programmed directly in the receiver.
Function DISPLAY MEMORY
This function can be used to display all the entries
programmed in the memory card, and to lock or unlock
transmitters. The display shows:
REG. CODE
TTTT XXXXXXX 1_N
REG. : entry number
CODE: transmitter code for this entry
C: channel
B: block; N = NOT blocked, Y = Blocked
The entry is locked or unlocked using the Ë key.
The $, & keys can be used to move around each of
the stored entries (TTTT). Moreover, pressing Ö and
entering the transmitter code (XXXXXXX, 7 digits)
shows the code for this entry.
C B
7
Publicidad
