Craftsman 580.752080 Instrucciones De Uso página 10

.
Before connecting garden hose to water inlet, inspect
inlet screen. Cleanscreen (A) if it contains debris or have
it replacedif damaged, DO NOTranpressurewasher if
inlet screen is damaged or missing.
4, Run water through garden hose for 30 seconds to flush
it of debris. Turn off water,
iMPORTANT: DO NOTsiphon standing water for the water
supply. Use ONLY cold water (less than IO0°F),
5, Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE
Using a One Way Vaive (vacuum breaker or check valve)
at pump inlet can cause pump or iniet connector damage.
ThereMUSTbeat leastten feet (3 m)of unrestricted garden
hosebetween the pressure washerinletandanydevice,suchas
a vacuumbreaker o r checkvalve.
Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty'.
6, Turn ONttle water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
NEVERsubstitute safety glasses for safety goggles.
ChecMist Befere Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1, Be sure to read Safety Rules and Operationsections
before using the pressure washer.
2, Make sure handle is in place and secure,
3, Checkthat eli has been added to proper level in engine
crankcase,
4. Add proper fuet to fuet tank.
5. Checkfor proper hose connections (high pressure and
water suppiy) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceed IO0°F).
10