Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Changing EngineOil
Changeengine oii after the first 5 hours and every 50 hours
thereafter, if you are using your pressure washer under
extremely dirty or dusty conditions, or in extremely hot
weather, change oil more often.
CAUTION
Avoid prolonged or repeatedskin contact with used motor
oil.
Usedmotoroil hasbeenshownto causeskin cancerin certain
laboratory animals.
Thoroughly washexposed areaswith soapandwater.
KEEPOUT OFREACHOFCHLDREN. DON'T
POLLUTE.CONSERVE RESOURCES. RETURN
USEDOIL TO COLLECTION CENTERS.
Change ell while engineis still warm from running, a s fellows:
1.
Make sure unit is on a ievei surface.
2.
Disconnect the spark plug wire from the spark plug and
place the wire where it cannot contact spark plug.
3.
Cleanarea around oiI drain plug (A). The oiI drain plug is
located at base of engine, opposite carburetor.
4.
Remove oii drain piug and drain oil completely into a
suitable container.
5.
Reinstall oil drain plug and tigllten securely. Remove oil
fiii cap.
6.
Siowly pour oil (about 20 oz.) into oil fill opening (B) to
the point of overflowing (C) at oil fill cap. DO NOT
overfill.
7.
Reinstati oii fill cap. Finger tigilten cap securely.
8.
Wipe up any spilled oil.
Service Air gleaner
Your engine wiii not run properly and may be damaged if you
run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of operation or
once each year, whichever comes first. Service more often if
operating under dirty or dusty conditions. Replacementsare
available at your local Searsservice center.
Te service the air cleaner,feiiew these steps:
1.
Loosen screw (A) and tilt cover (B) down.
2.
Carefully remove cartridge (C) assembly.
3.
To clean cartridge, gently tap pleated paper side on a fiat
surface.
4.
Reinstaii ciean or new cartridge assembly inside cover.
5.
Insert cover's tabs (O) into slots in bottom of base (E).
6.
Tilt cover up and tigilten screw securely to base.
NOTE:You can purchase new air filter elements by calling
l=800=4=_,IY=NO_,'IE
(469-4663).
Service Spark Plug
Service the spark piug every 100 hours of operation or
yearly, whichever occurs first.
1.
Cleanarea around spark plug.
2.
Removeand inspect spark plug.
3.
Repiacespark piug if eiectrodes are pitted, burned or
porcelain is cracked. Use the recommended replacement
plug. See Specificah;ons.
4.
Checkeiectrode gap with wire feeier gauge and set spark
plug gap to 0.030 inch (0.76 ram) if necessary.
5.
Instaii spark piug and tighten firmly.
NOTE:You can purchase a new spark plug by calling
l=808o4=MY=NOME ( 469o4663).
2O
Publicidad
Tabla de contenido
