Craftsman 580.752080 Instrucciones De Uso página 11

HOWTO USEYOUR PRESSURE WASHER
If you haveany problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
Pressure Washer Lecatien
Pressure WasherClearance
WARNING
Exhaustheat/gases can ignite combustibbs,
structures or damage fuei tank causing a fire.
o Keepat least5 ft. (152 crn)clearance on all sidesof pressure
washerincludh_g overhead.
Placepressure washer outdoors in an area that wiii not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentiaily occupied building.
Ensureexhaust gas is kept away from any windows, doors,
ventiiation intakes, or other openings that can aliow exhaust
gas to coIiect in a confined area. Prevaiiingwinds and air
currents should be taken into consideration when positioning
_ressurewasher.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathingcarbon monoxide can cause headache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea, fainting or death.
° Operate pressure washerONLYoutdoors.
o Keepexhaustgasfrornenteringa confinedareathrough
windows,doors,ventilationintakes, o r otheropenings.
* DONOT star or run engineindoorsor in an enclosed area,
evenif windowsanddoorsare open.
To Start Your Pressure Washer
To start your engine=poweredpressure washer for the first
time, foiiow these instructions step=by=step. T his information
also applies whenever you start the engine after you have let
the pressure washer sit idle for at bast a day.
1. Placepressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.8 galions per minute and no iess than 20 PSi at
pressure washer end of garden hose.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. See Assembyfor illustrations.
3. Make sure unit is in a ievel position.
4. Connectgarden hose to water inlet on pressure washer
pump.
5. Turn ONthe water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
i OTlCE
DO NOT run the pump without the water supply connected
and turned on.
Damage to equipment r esultingfrom failureto followthis
instructionwill void warranty
6. Attach nozzleextension to spray gun. Tighten by hand.
Choose ProjectPro
TM
nozzleyou want to use, puff back
on coliar of nozzle extension, insert nozzle and reiease
coiiar. Tug on nozzle to make sure it is securely in place.
See How to Use ProjectProTM IVozz/e System.
8. Rotate fuel shut-off valve to "On" position (A) (fully
counter=clockwise).
11