Additional Information - Alpine VPE-V180A Manual De Operación

Special functions -
Index Search Function
You can easily locate the desired program using
the index signal registered on the tape.
An index signal is automatically registered when a
recording starts, or press INDEX at a desired point
during recording.
Index Scan
This function plays back the tape for about 5 sec-
onds at each index signal.
1.
Press INDEX during playback or stop mode.
2.
Press (REW) or (FF) to search in the
reverse or forward direction.
3.
Press (PLAY) when the desired program is
found. Normal playback starts.
Index Search
This function fast-forwards or rewinds the tape to
the point at which the selected index signal is reg-
istered, and starts playback from there.
1.
Press INDEX during playback or stop mode.
2.
Press TRACKING/SELECT
ing to the direction where your desired program
is located. Each time the button is pressed, the
number decreases or increases respectively.
3.
Press (REW) or (FF) to search in the
reverse or forward direction. When the point is
found, playback will start automatically
Tip
• An index signal is not registered when the VCR
is in the recording pause mode and recording
restarts.
• You can set up index numbers to a maximum of
±99.
• Index search function is cancelled when the
(PLAY) or (STOP) is pressed.
VPE-V180A_English
All manuals and user guides at all-guides.com
Continued
Auto operation function
Auto Repeat
When the tape ends, it rewinds and plays auto-
matically. Then the function repeats while the auto
repeat mode is activated.
• Press (PLAY) during playback.
The indicator appears on the monitor screen.
Press again to cancel this feature.
Auto play after rewinding
• Press (PLAY) for more than 3 seconds during
rewinding to start playback automatically after
rewinding.
The indicator appears on the monitor screen.
Press (STOP) to cancel this feature.
Auto Power-off after rewinding
• Press POWER during rewinding to turn off auto-
matically after rewinding.
The indicator appears on the monitor screen.
Press (STOP) to cancel this feature.
correspond-
9

Additional Information

Moisture indicator
The MOISTURE indicator and an on-screen mes-
sage will inform you if the unit reaches abnormal
temperature or condensation levels. As a result,
the unit will not operate until it dries out sufficiently.
When the MOISTURE indicator blinks, leave the
unit on for approximately a few hours to allow it to
dry out completely.
Note
Be sure to wait for the MOISTURE indicator to stop
blinking before turning the unit off. If the unit is
turned off before the indicator stops blinking, the
next time it is turned on, the indicator will blink again
for several minutes.
In areas where the interior of the vehicle becomes
extremely hot or cold, allow the temperature to re-
turn to a comfortable level before operating the VCR.
Do not leave tapes in your vehicle or in the VCR as
extreme temperature will damage the cassette.
4/25/00, 2:02 PM
English
E-9