3M Filtrete Single Stage Guía De Uso Y Cuidado página 5

MOUNTING THE FILTER
HEAD ASSEMBLY:
You will need: Phillips screwdriver, drill, pencil,
safety glasses, filter (A), head assembly (B),
#2 mounting screws (L)
1. Choose a location to mount filter head assembly
(B). Keep in mind: Filter head should be in
a location that offers easy access for changing
filters. Leave 2 ½" of clearance below the installed
filter cartridge. (See Fig. 6)
2. Using the bracket on the head (B) as a guide,
mark the location of the two screw holes on the
wall with a pencil. (Fig. 7)
3. Fasten the head to the wall using a Phillips
screwdriver and the two mounting screws
included (L) (Fig. 8). (If preferred, use a drill
with a 1/8" size drill bit to make pilot holes
for the screws.)
4. Check to assure mounting bracket is
firmly installed.
ATTACH WATER SUPPLY
LINE ADAPTER:
You will need: Adjustable wrench (Note: Two
wrenches may be needed to adequately tighten
fittings when connecting the adapter to the
supply line), water supply line adapter (E), water
supply line seal (F)
1. Turn off the cold water supply at the shutoff
valve under the sink. (Fig. 9)
2. Place bowl under cold water connection.
Disconnect the cold water faucet hose from
the shutoff valve below using wrenches.
Leave the hose attached to the faucet
above. (Fig. 10)
3. Ensure the water supply line seal (F) is properly
inserted into female threaded portion of water supply
line adapter (E).
4. Install water supply line adapter on water supply
shut-off valve. (Fig. 11)
5. Reconnect the cold water faucet hose onto threaded
portion of water supply line adapter. (Fig. 11)
Note: If the water supply line adapter (E)
does NOT fit properly onto the end of your
shutoff valve, visit your local hardware store
to purchase the correct size.
2 / "
1
2
2 / "
1
2
(Fig. 6)
(Fig. 6)
(Fig. 9)
(Fig. 9)
(Fig. 10)
(Fig. 10)
5
(Fig. 7)
(Fig. 7)
(Fig. 8)
(Fig. 8)
(Fig. 11)
(Fig. 11)