3M Filtrete Single Stage Guía De Uso Y Cuidado página 6

ATTACH WATER
INLET/OUTLET HOSES:
You will need: 1 length of 1/4" tubing (D).
1. Insert one end of the length of 1/4" tubing (D) into
the push-in fitting on the side of the water supply
line adapter (E) you just installed. Push the tubing
in firmly as far as it will go to ensure a watertight fit.
(Fig. 12) Important Note: Water may leak if the tube
is not pushed in completely. (See "push-in fittings"
explanation on Pg. 3. Fig. 1)
2. Take the other end of the same 1/4" tubing (D)
and insert into the right (inlet) side of the filter
head assembly (B). (Fig. 13)
3. Insert the end of the faucet tubing into the left (outlet)
side of the filter head assembly (B). (Fig. 14)
ATTACH THE FILTER:
You will need: filter (A)
1. Insert the filter (A) into the filter head (B).
2. Push filter up, then turn one quarter
of a turn to the right until it stops.
(Fig. 15)
3. When properly attached, there will
be NO gap between the filter head (B)
and the filter (A).
TURN WATER ON:
1. Turn the water back on at the
cold water shut-off valve. (Fig. 16)
2. Open dedicated faucet to flush 2 gallons
(approx. 4 minutes.) through the system
before use. Water may appear cloudy, but
will turn clear as the trapped air is released.
3. Check for leaks. If any dripping or leaking
occurs, turn cold water supply off, open both
faucets, tighten fittings and ensure that tubing is
pushed completely into fittings.
4. Activate filter change indicator according to
instructions on page 8.
YOUR SYSTEM IS NOW READY FOR USE.
(Fig. 12)
(Fig. 13)
(Fig. 14)
(Fig. 15)
6
(Fig. 16)