Consumer Information - Moen 85900 Serie Manual De Usario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FLUSHING INSTRUCTIONS
IMPORTANT: Pipe chips, sand, stones and other solids found in new and renovated plumbing can damage the sealing
surfaces of the cartridge and cause leaks. To avoid damage, DO NOT TURN ON SUPPLY VALVES until instructed below.
1. After installing and connecting your new faucet, make sure that the handles are in the on or open position
(rotate the cold handle in the clockwise direction, the hot handle in a counter-clockwise direction).
2. Open hot and cold water shut off valves and allow the water to run for 15 seconds.
3. Turn both handles to the off or closed position (counter clockwise for cold, clockwise for hot),
unscrew the aerator from the end of spout and clean any debris from the aerator screen.
4. Replace the aerator and check system for leaks.
DISASSEMBLY
1
1. MONTICELLO MODELS:
Holding the lever (1) or cross
(10) handle with one hand,
unscrew the handle hub (4)
counterclockwise as shown
above and set aside.
MOEN LIFETIME LIMITED WARRANTY
Moen products have been manufactured under the highest standards of quality and workmanship.
Moen warrants to the original consumer purchaser for as long as the original consumer purchaser
owns their home (the "Warranty Period" for homeowners), that this faucet will be leak and drip-free
during normal use and all parts and finishes of this faucet will be free from defects in material and
manufacturing workmanship. All other purchasers (including purchasers for industrial, commercial and
business use) are warranted for a period of 5 years from the original date of purchase
(the "Warranty Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF
CHARGE provide the parts necessary to put the faucet back in good working condition and will replace
FREE OF CHARGE, any part or finish that proves defective in material and manufacturing workmanship,
under normal installation, use and service. Replacement parts may be obtained by calling 1-800-289-6636
(Canada 1-800-465-6130), or by writing to the address shown. Proof of purchase (original sales receipt)
from the original consumer purchaser must accompany all warranty claims. Defects or damage caused
by the use of other than genuine Moen parts are not covered by this warranty. This warranty is applicable
only to faucets purchased after December 1995 and shall be effective from the date of purchase as shown
on purchaser's receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes. However,
damage due to installation error, product abuse, product misuse, or use of cleaners containing abrasives,
alcohol or other organic solvents, whether performed by a contractor, service company, or yourself, are
excluded from this warranty. Moen will not be responsible for labor charges and/or damage incurred in
installation, repair or replacement, nor for any indirect, incidental or consequential damages, losses,
injury or costs of any nature relating to this faucet. Except as provided by law, this warranty is in lieu of
and excludes all other warranties, conditions and guarantees, whether expressed or implied, statutory or
otherwise, including without restriction those of merchantability or of fitness for use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to you. This warranty
gives you specific legal rights and you may also have other rights which vary from state to state, province
to province, nation to nation. Moen will advise you of the procedure to follow in making warranty claims.
Simply write to Moen Incorporated using the address below. Explain the defect and include proof of
purchase and your name, address, area code and telephone number.
3
2
12
13
14
TRADITIONAL MODELS: Use
a thin bladed instrument to pry
off plug button (12). Remove
handle screw (13). Pull handle
hub (14) up and set aside.
2. Remove cartridge nut (17).
3
17
18
3. Grasp the stem of cartridge
(18) with pliers and pull
straight up. This will remove
the cartridge as one unit.
For reassembly reverse the
steps above.

CONSUMER INFORMATION

Faucets made of leaded brass alloys may contribute small amounts of lead
to water that is allowed to stand in contact with the brass. The amount of lead
contributed by any faucet is highest when the faucet is new. The following steps
may reduce potential exposure to lead from faucets and other parts of the
plumbing system:
• Always run the water for a few seconds prior to use for drinking or cooking
• Use only cold water for drinking or cooking
• If you wish to flush the entire plumbing system of water that has been
standing in the pipes or other fittings, run the cold water until the temperature
of the water drops, indicating water coming from the outside main
• If you are concerned about lead in your water, have your water tested
by a certified laboratory in your area
In the U.S. call our toll free Helpline number for answers
to any product, installation, or warranty questions.
Moen Incorporated • 25300 Al Moen Drive • North Olmsted, OH 44070-8022 U.S.A.
In Canada Moen Inc. • 2816 Bristol Circle • Oakville, Ontario L6H5s7
4
STEM
TIGE
VÁSTAGO
CAUTION: Be careful not to
!
damage the rubber seals when
reinstalling cartridge. During
installation be sure of the following:
• Stem must be in open position
• Key in cartridge fits into notch on
body
• Start cartridge nut by hand,
do not cross thread
• Tighten firmly
HELPLINE:
1 (800) BUY-MOEN
[289-6636]
In Canada:
Toronto: 905-829-3400;
Rest of Canada: 1-800-465-6130
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84-345
INS178B
KEY
CLÉ
CANDA
NOTCH
ENCOCHE
MUESCA

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5900 serie

Tabla de contenido