Installation Instructions - Moen 85900 Serie Manual De Usario

INSTALLATION INSTRUCTIONS

CAUTION:
!
Always turn water OFF before removing existing faucet or disassembling the valve.
Open valve handles to relieve water pressure and insure that complete water shut-off has been accomplished.
Before installing new faucet make sure that the cartridge nuts are in place. The cartridge and cartridge nuts were properly installed and
tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number
of persons the cartridge nuts may not be properly installed. This should be carefully checked at time of installation. If the cartridge nuts
are not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises
could result.
1
22
24
23
1. Be sure mounting area is clean and dry. Slide deck gasket
(24),over valve shanks (23) and up against deck plate (22).
Holding faucet assembly upside down, place a 1/4" (6mm)
bead of plumber's putty on the bottom of the deck gasket.
Place faucet in position on the sink, being careful not to
disturb the putty bead. From under the sink, thread mounting
nut/washer (25) (large side up) onto valve shanks (23). Check
faucet position on sink top, and align and match escutcheon
gasket to escutcheon, then HAND-TIGHTEN. Trim excess gas-
ket from around escutcheon. Connect supplies to faucet shank.
If using flexible supply lines, thread onto faucet supplies finger
tight, then tighten with a wrench by rotating one half turn.
3
1 2
3
5
4
15
24
3a. HANDLE INSERT ASSEMBLY
6 7
8
9
11
10
4
12 12
13
3b. HANDLE ASSEMBLY INSTALLATION
16
14
3c. ALL MODELS
2
23
2. Traditional models - Rotate spout assembly (33) to
desired location. Make sure spout hub (32) is hand tightened.
Monticello models - Rotate spout assembly (35) to
desired location. Make sure spout hub (32) is hand tightened.
(some models come pre-assembled)
MONTICELLO LEVER HANDLE MODELS (5)
Install lever handle (1) with color ring (2) into
handle hub/elbow assembly (3 & 4) and hand tighten.
MONTICELLO CROSS HANDLE MODELS (11)
Place cross handle insert (9) onto handle skirt (10),
insert handle screw (7) through color ring (8) and cross handle
insert and tighten. Install plug button (6) over screw head.
TRADITIONAL LEVER HANDLE MODELS (16)
Install lever handle (15) into handle hub (14).
Be sure that o-ring is in place on insert.
MONTICELLO MODELS:
Use the handle assembly with the red adapter (inside handle hub (4)) for
the hot side and blue adapter for the cold side. Position handle assembly
(5) or (11) on to cartridge stem by aligning curve on stem with curve inside
handle assembly. Rotate lever (1) or cross handle (9) until handle assembly
seats. While holding the lever handle in the open position, hand tighten
handle hub (4) CLOCKWISE.
TRADITIONAL MODELS:
Align and seat handle hub (14) on to valve.
Insert handle screw (13) and snap plug button in place.
Make connections to supply lines.
Faucet flushing is required, see faucet flushing instructions on page 3.
33
32
35
32
2