How To Assemble Your Ceiling Fan - Fanimation The Keistone FPD8088-NL Serie Manual Del Propietário

1. Prior to assembly, set aside and save the hardware
bags included with the fan. Remove the hanger ball
by loosening the setscrew in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the danger ball.
Retain the pin and hanger ball for reinstallation in
Step 7. (Figure1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 2)
3. Remove and discard the coupler supporter from
motor assembly by removing the screws. (Figure 3)
4. The fan comes with black and white 80"
Separate and untwist the two wires. Route the
wires the wires through the downrod.
NOTE: You will be using either the 4½" downrod
supplied with your fan or an optional downrod
purchased separately.
Loosen the two setscrews in the downro d support.
n I t s l l a d o w n o r d n i o t c
holes in the downrod with the holes in the downrod
support. (Figure 4)
5. Install the clevis pin, hairpin clip and tighten set
screws. The clevis pin and hair pin clip must be
properly installed to prevent the set screws from
working loose. (Figure 5)
▲
WARNING
It is critical that the clevis pin in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis pin, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.

How to Assemble Your Ceiling Fan

wires.
o u p e l . r A g i l n h t e c e l v s i p
Hanger
Ball
Coupler supporter
Downrod
Set Screw
n i
Hairpin
Clip
6
Figure 1
Hairpin
Clip
Figure 2
Figure 3
Figure 4
Figure 5
Pin
Setscrew
Clevis Pin
Clevis Screw
w/Rubber
Washers (2),
Locknut
Set Screw
w/Hex Nut
Rubber
Washer (2ea)